Posted 07/26/18,

In my last post on this subject, I described my efforts to troubleshoot an intermittent ‘bad data’ problem I experienced with the Inversense MPU6050/DMP breakout board from DFRobots.   The calculated yaw value would occasionally ‘lose synch with reality’ and start varying wildly.   I finally tracked this down to occasional bad reads from the DMP FIFO; the read would extract bytes from two different packets, producing an invalid yaw value.   The fix for this problem is to monitor the FIFO ‘bytes remaining’ count and reset the FIFO whenever the ‘bytes remaining’ count is not an integral multiple of the packet size.

After demonstrating that I could run the MPU6050 for days (literally) without any bad data occurrences, I thought I was home free in my effort to provide relative heading information for precise turns, but I ran into yet another problem when I tried to integrate the MPU6050 back onto the robot.   This time the problem was a hangup problem; after some tens of minutes, the program would stop responding at all – as if it had gone into an infinite loop somewhere (which is exactly what was happening, but I’m getting ahead of myself…).

This problem turned out to be a ‘simple’ I2C wire-length issue; I was able to demonstrate that the problem would occur any time the I2C ICL/SDA wire length went beyond about 42 cm, and would not occur with wire lengths below about 30 cm.   The problem did not appear to be sensitive to I2C bus speed (at least not for the default 100KHz or for a reduced clock speed of 50KHz) or pullup resistor value – just to wire length.

The rest of this post is a copy of my troubleshooting notes from the effort to track this problem down and solve it.   I have found in the past that when facing a non-trivial problem with multiple possible causal factors, a troubleshooting journal is an absolute must.   In the pre-computer days (you do remember there was a time before ubiquitous computing don’t you?), I used a real MIT engineering notebook for this purpose, and then later on a 3-ring binder into which I added quadrille-ruled sheets covered with my notes and drawings.   Then I moved on to Word documents – nicer because I could include Excel plots, Visio drawings, photos, and other mixed media.   Now that I have graduated to a WordPress blog, I can use it as a repository of my working notes, while also allowing others to see the inner workings of a mad scientist’s mind ;-).

I2C Hangup problem with Inversense MPU6050

Stay tuned,

Frank